Overview
The AMP-Research PowerStep Plug and Play Pass Through Harness is a black harness made for part number 76154. It has a plug and play design and must match your PowerStep board.
Key features
- Plug and play pass through design
- Black finish
- Built for use with part number 76154
- Not tied to one vehicle model.
Connector care and harness routing
A pass through harness carries power and signal wiring between the vehicle and the running board, so its connectors take most of the stress during installation. Route the harness away from moving parts, sharp edges and heat sources, and secure it with clips so it cannot rub or hang low. Strain relief at each plug keeps the connection from pulling apart when the board moves.
Plug connectors can corrode when water and road salt get into the housing. Seal exposed contacts with dielectric grease where the design allows, and keep the mating faces dry before pushing them together. Check connectors each season for cracked housings, bent pins and discolored terminals, and replace damaged parts rather than repairing wiring under the vehicle.
- Route away from heat and moving parts
- Use strain relief at each plug
- Inspect terminals each season
Specifications
| Brand | AMP-Research |
|---|---|
| Product | PowerStep™ Plug and Play Pass Through Harness |
| For use with | Part number 76154 |
| Finish | Black |
| UPC | 815410012105 |
Vehicle fitment
It is not tied to one vehicle model. Confirm it matches your PowerStep board and part number 76154 before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The harness uses a plug and play design. Confirm the connector matches part number 76154 before installing.
What’s included
The pass through harness, black.
Not included: The PowerStep power running board itself; the harness is made for use with part number 76154 and the board is not part of this product.












