Overview
AMP-Research’s 75118-01A is a black PowerStep running board kit in cab length, rated at 600 lb per side. The electric steps lower as a door opens and fold up when the doors close, and the kit includes an integrated LED light system as standard.
The linkage is high-strength die-cast aluminum alloy, and optional stainless-steel trim is available. An anodized and Teflon finish resists corrosion, and the steps carry a textured powder coat for grip. Fitment is a Direct Fit designation for cab length, so confirm your vehicle before ordering.
Key features
- Electric steps that lower on door open and fold up on door close
- Integrated LED light system, standard
- High-strength die-cast aluminum-alloy linkage components
- Anodized and Teflon finish to resist corrosion
- Zero-maintenance stainless-steel pivot pins
- Textured powder-coat finish for grip
- Optional stainless-steel trim available
- Designed and made in the U.S.A.
Setup before installation
Running boards with electric steps combine a mechanical linkage, a drive, and a light circuit, so the planning goes beyond bolting a board to the frame. Start by reviewing the mounting points and the cab fit, then lay out the wiring so it stays clear of the moving arms. Most owners find that a short layout check prevents rubbing and pinched wires later.
Once installed, check the steps through a full cycle of deploy and stow. Listen for binding, watch the lights for consistent operation, and make sure the steps stop cleanly without contacting the body. Corrosion resistance depends on keeping the finish intact, so touch up any chips in the powder coat before rust can start.
- Confirm mounting points before drilling
- Route wiring away from the linkage
- Touch up chips in the powder coat promptly
Specifications
| Brand | AMP-Research |
|---|---|
| Part number | 75118-01A |
| UPC | 815410010255 |
| Finish | Black |
| Length | Cab |
| Fitment | Direct Fit (no vehicles named) |
| Load capacity | 600 lb per side |
| Lighting | Integrated LED light system, standard |
| Warranty | 5-year/60,000-mile |
Vehicle fitment
This part carries a Direct Fit designation for cab length. Confirm fit for your vehicle’s year, model and trim before ordering.
Compare the part number 75118-01A with the number on any existing running board before assuming a match. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Route the wiring clear of the moving linkage and make sure the connectors are fully seated before testing the lights.
What’s included
The kit includes the running boards with integrated lighting and optional trim. Check the package contents against your installation before starting.
Not included: Confirm that brackets and hardware suited to your vehicle are on hand before installation.












