Overview
The Powermaster 8002 is a 100 amp high-output alternator for 1963–1983 Chevrolet and GMC C/K trucks and Suburbans, and for selected 1975–1983 Jeep models. It bolts in place of the original alternator, with a slightly larger case that fits all factory brackets and uses the same belt.
Adding driving lights, auxiliary cooling fans or a large sound system can push a stock Jeep alternator past its capacity. This design is reengineered to produce up to 50% more output at idle, and each unit is tested and comes with a proof of performance tag.
Key features
- 100 amperes rated output
- Bolt-in replacement with a slightly larger case that fits factory brackets
- Uses the same belt as the original alternator
- Reengineered power curve for up to 50% more output at idle
- One-Wire wiring setup
- Natural finish and proof of performance tag
Electrical load and idle output
An alternator keeps the battery charged and supplies the vehicle’s electrical loads while the engine runs. Output at idle matters most in stop-and-go driving, when cooling fans and lights draw power but the engine turns slowly. A stronger idle charge helps keep system voltage steady in those conditions, which is when older trucks and Jeeps often show dimming lights or a battery that slowly drains.
Before buying, add up the accessories you run at the same time, such as winches, auxiliary lights, radios and fans, and compare that total with the rated output. A new alternator works best with a battery in good condition and clean, tight ground connections, because a weak ground can limit what the unit delivers. After installation, look over the drive belt for glazing or cracks and recheck its tension after the first few drives.
- Clean the battery and engine ground connections before installing
- Watch for dim lights at idle as a sign of a weak charge
- Use a voltmeter to check charging with the engine running
Specifications
| Brand | Powermaster |
|---|---|
| Part number | 8002 |
| UPC | 692209000938 |
| Amperage | 100 amperes (also written 100/70 amp) |
| Wiring | One-Wire |
| Fitment type | Direct fit |
| Finish | Natural |
| Engine applications | 258 six-cylinder and 304 V8 engines |
Vehicle fitment
It fits Chevrolet and GMC C/K pickups and Suburbans from 1963 to 1983, Chevrolet Blazer and El Camino models, and Jeep Cherokee (SJ), Wagoneer (SJ), CJ5, CJ6, CJ7, J10 and J20 models from 1975 to 1983.
Model years after 1983 and vehicles such as the Jeep TJ, XJ and Wrangler are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a bolt-in swap for the original alternator, so the factory brackets and belt are reused. Disconnect the battery before removing or installing the alternator.
What’s included
Each tested unit comes with a proof of performance tag.
Not included: Check the belt and mounting hardware against your installation before starting.












