Overview
The Power Stop S2870B is a front pair of powder-coated performance brake calipers for the 2008–2012 INFINITI EX35, 2013 EX37, 2014–2015 QX50, 2014–2016 QX70 and 2011–2014 Nissan Murano. One left and one right caliper make up the set.
These calipers are aimed at enthusiasts who want a straightforward swap. Power Stop states they bolt in where the original calipers sit, and that the caliper and bracket are remanufactured in the USA. A red high-temperature powder coat gives the calipers a finished look behind open wheel designs. Inside, Power Stop fits new premium boots and seals, so the sliding surfaces and fluid passages are protected, and it adds silicone lubricant on the caliper pins for long life.
Key features
- Front pair of calipers with left and right sides
- Direct bolt-in replacement for the stock calipers
- Remanufactured in the USA, caliper and bracket
- Red high-temperature powder coating
- New premium boots and seals
- Silicone pin lubricant that tolerates high temperature
- Abutment clips included where applicable
Matching the caliper set
Calipers and their brackets carry most of the clamping load, so a matched pair helps the front wheels brake evenly. Replacing one side alone can cause pull under braking, and a new caliper on an old rotor can drag or wear pads unevenly. Measure the rotor thickness and check for runout before installation.
Red powder-coated calipers are a finish choice, and the coating does not change the hydraulic design. Pads, fluid and rotors are separate purchases, so budget for them with the calipers. Pad compound choice affects noise and dust, so pick a pad that suits your driving.
- Replace both front calipers together
- Use fresh brake fluid after the swap
- Clean the caliper pin bores before fitting
- Check the abutment clip seating
Specifications
| Brand | Power Stop |
|---|---|
| Part number | S2870B |
| UPC | 792088839664 |
| Part type | Performance brake calipers |
| Position | Front |
| Set contents | 1 left caliper and 1 right caliper |
| Finish | High-temperature red powder coat |
| Origin of remanufacture | USA |
| Seals | New premium boots and seals |
| Fit type | Direct fit |
Vehicle fitment
The Power Stop fitment list for the S2870B names the 2008–2012 INFINITI EX35, the 2013 INFINITI EX37, the 2014–2015 INFINITI QX50, the 2014–2016 INFINITI QX70 and the 2011–2014 Nissan Murano.
Only those model years are listed. The EX37 appears for 2013 alone and the Murano starts at 2011, so match your model year exactly rather than assuming a neighboring year is covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The calipers bolt in where the original units sit. Bleed the brake system after installation, since the calipers are part of the hydraulic circuit, and confirm firm pedal feel before driving.
What’s included
- One left front caliper and one right front caliper
- Brackets, which Power Stop says are remanufactured along with the calipers
- New premium boots and seals
- Silicone lubricant for the caliper pins
- Abutment clips where they apply
Not included: Pads, rotors, brake fluid and other hardware beyond the items above.











