Overview
The Power Stop SW-0510 is a front brake pad wear sensor and a plug-and-play replacement for the electronic pad wear sensor on Mercedes-Benz G55, GL-Class and ML-Class models.
Power Stop says professional installers recommend replacing the sensor whenever the pads are changed, because sensors are susceptible to failure with high thermal duty cycling. It says its sensors are made to withstand high temperatures and keep good electrode conductivity, and they are part of its Euro-Stop program.
About this part
Many European vehicles use a wire-style wear sensor in the pad that completes a circuit when the friction material wears down to a set point, lighting a warning on the dash. The sensor is single use because the wire wears through, so it should be changed with each set of pads. Its fitment covers specific G-Class, GL-Class and ML-Class years.
Key features
- Direct plug-and-play replacement for electronic pad wear sensors
- Withstands heat stress up to 500 degrees
- Super conductive electrodes
- Front position
- Replacement recommended with every brake job
- A new sensor is needed for the dash indicator to work once pad wear reaches 50%, even after fitting new pads
Replacing sensors with pads
Wire-style and electronic wear sensors work the same way: once the pad reaches its wear limit, the circuit changes state and the dash light comes on. A worn sensor is often damaged by the wear itself, so it is practical to treat it as a service part and change it when the pads go. That keeps the indicator tied to the new pad thickness rather than an old, weakened unit.
Front brakes run hot, and heat cycling is the main stress on the sensor and its lead. Route the lead the same way as the original, secure it with the existing clips, and check that it cannot rub against the disc or caliper. Recheck the dash after a short drive to confirm the indicator reads normally.
- Use the original clip positions
- Recheck the indicator after the first drive
Specifications
| Brand | Power Stop |
|---|---|
| Part number | SW-0510 |
| UPC | 792088524379 |
| Product type | Brake pad wear sensor |
| Brake position | Front |
| Heat tolerance | Up to 500 degrees |
| Electrodes | Super conductive |
| Connection | Plug and play |
| Program | Euro-Stop |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Power Stop SW-0510 includes the following vehicles and trims:
- 2005–2011 Mercedes-Benz G55 (AMG Base)
- 2007–2009 Mercedes-Benz GL320 (Bluetec 4Matic, CDI)
- 2010–2012 Mercedes-Benz GL350 (Bluetec 4Matic)
- 2007–2012 Mercedes-Benz GL450 (Base)
- 2008–2012 Mercedes-Benz GL550 (Base)
- 2007–2009 Mercedes-Benz ML320 (Bluetec 4Matic, CDI)
- 2006–2012 Mercedes-Benz ML350 (4Matic, Bluetec 4Matic)
- 2006–2007 Mercedes-Benz ML500 (Base)
- 2008–2012 Mercedes-Benz ML550 (Base)
- 2007–2011 Mercedes-Benz ML63 (AMG Base)
The list covers specific Mercedes-Benz G-Class, GL-Class and ML-Class years only; other Mercedes-Benz models and the rear axle are not covered by this front sensor. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The swap is a plug-and-play task, and replacing the sensor with every brake job keeps the dash indicator accurate. Once pad wear passes 50%, a new sensor is needed for the indicator to work, even if the pads are replaced.
What’s included
One brake pad wear sensor. Euro-Stop sensors come either individually boxed or packaged with pads.
Not included: Brake pads.









