Overview
The Poison Spyder TJSPECIAL09 is a front and rear bumper set in bare 3/16″ plate steel, pairing a front bumper with a Brawler Bar and the BFH II frame cap rear bumper. Poison Spyder named the BFH series for “Built For the Hammers”, and designed it for hardcore four-wheelers who want strength and simplicity.
The front bumper is no wider than the Jeep’s frame rails and has an integrated winch mount in a one-piece design. The Brawler Bar extends 7.4″ forward of the bumper’s front edge and rises 9.8″ above its top surface. The BFH II rear bumper hugs the Jeep’s frame and crossmember for obstacle clearance and departure angle, and has no provision for a spare tire carrier.
Key features
- One-piece front bumper laser-cut from high strength 3/16″ plate steel
- Integrated winch mount
- Brawler Bar extends 7.4″ forward and is 9.8″ high from the top surface of the bumper
- Recovery shackle tabs machined from 1″ thick plate steel for 3/4″ recovery shackles
- Frame cap style BFH II rear bumper that wraps the rear frame and crossmember
- Rear shackle tabs welded inside and outside the bumper shell
- Universal mounting system with captured Grade 8 hardware
- Bare steel only
Frame cap rear bumpers
A frame cap rear bumper wraps around the rear frame and crossmember instead of sitting out past the body, so the body stays close to the frame and the approach and departure angles stay clean. This style gives up a spare tire mount in exchange for a compact rear profile and a strong connection to the frame structure.
Because the bumper hugs the frame, the mounting points and the frame itself take the load in a recovery. Check the bumper-to-frame connections and welds after hard use, and look for cracks where the bumper meets the crossmember. Clean mud from the seams so early movement is easy to spot.
Front and rear bumpers on a Jeep work together. A winch bumper with a Brawler Bar adds weight at the front, so match the rear bumper and suspension setup to keep the vehicle balanced and the steering responsive on loose ground.
- Inspect frame-to-bumper welds after hard recoveries
- Clean the seams so movement is easy to spot
- Plan how a spare will ride if you run one
Specifications
| Brand | Poison Spyder |
|---|---|
| Part number | TJSPECIAL09 |
| UPC | 700007616921 |
| Type | Front and rear bumper set |
| Material | 3/16″ plate steel |
| Finish | Bare steel |
| Brawler Bar projection | 7.4″ forward, 9.8″ high |
| Shackle tab stock | 1″ thick plate steel, for 3/4″ shackles |
| Rear hardware | Grade 8, captured |
Vehicle fitment
This set is built around the frame rails and rear crossmember of the Jeep it is mounted to. Verify the year, model and trim against your Jeep before buying.
Check the mounting holes on your frame and crossmember against both bumpers before you begin installation, and make sure the year, model and trim line up.
Installation notes
The BFH II rear bumper is installed with captured grade-8 hardware and the Jeep’s existing bumper mounting holes. It is intended for wheelers who run without a spare or strap the spare down in the bed. Both bumpers are bare steel and must be painted or powder coated before final installation.
What’s included
- Front bumper with Brawler Bar
- BFH II rear bumper
- Recovery shackle tabs
- Captured Grade 8 mounting hardware
Not included: a winch, fairlead and paint or powder coat.






















