Overview
The PCI Race Radios In Helmet Headset helmet wiring kit, part number 218, connects an in-helmet headset to a PCI communication system. It is universal fit, so the match depends on your helmet and PCI system rather than on a vehicle.
PCI has worked in racing communications since 1972, when its founder began installing radios in race vehicles. The company name is meant to stand for quality, service and support.
Key features
- Helmet wiring kit for in-helmet headset setups
- Connects a helmet headset to a PCI intercom or radio system
- Universal fit, not vehicle-specific
Routing wires in the helmet
Routing matters more than most people expect. Run the wires along the liner edges rather than across the padding, and leave enough slack for head movement so the cord does not pull at the connector. Keep the wires away from the chin strap buckle, where repeated pinching can cut through the insulation over time.
Test the system before closing up the helmet. Check audio on both sides and with the microphone keyed, then flex the cable at each connection point to find intermittent faults. Strain relief clips and cable ties help keep the wiring stable, and headsets and microphone booms are often replaced at the same time when a setup is upgraded.
- Leave slack at the helmet exit point
- Secure wires with clips rather than tape
- Re-test audio after each wire adjustment
Specifications
| Brand | PCI Race Radios |
|---|---|
| Part number | 218 |
| Part type | Headset accessory (helmet wiring kit) |
| Fitment | Universal |
Vehicle fitment
This wiring kit is universal fit and is not vehicle-specific. It is used with the helmet and the communication system, so the match depends on your helmet and PCI system rather than the vehicle.
Installation notes
Before installing, check the helmet and headset setup against the PCI system you are using.
What’s included
This part number covers the helmet wiring kit itself. Check the wire length and connector type against your helmet and headset before ordering.









