Overview
The Omix-ADA 16714.06 is a direct replacement wheel stud for Jeep vehicles, built to original specifications. Five are required per axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Stud replacement basics
A wheel stud carries the clamping load of the wheel through the hub flange. It is pressed or held into the hub and threads through the wheel, so the knurled section and the thread both matter. A stud that spins in the hub or that has worn threads cannot hold the nut torque properly, which can let the wheel shift or loosen over time.
When replacing studs, look at the hub flange for damage and rust around the stud base. Clean the bore so the new stud seats fully. Install the studs evenly around the hub and check each one for solid seating before mounting the wheel. Replacing a few studs while the others are worn can leave uneven loading.
After installation, tighten the lug nuts in a star pattern and re-check them after the first few drives. Look for stretched threads or rust trails at the stud base, since these are early signs the stud is not holding.
- Inspect the hub flange around each stud
- Clean the bore before pressing in a new stud
- Re-check lug nut torque after initial driving
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16714.06 |
| UPC | 804314034788 |
| Required per axle | Five |
| Design | Direct OE replacement |
| Warranty | Limited five year warranty from Omix-ADA. |
Vehicle fitment
Direct fit for Jeep vehicles. Verify thread and length against the original hardware on your axle before installing.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Wheel stud. Count the studs in your package against the five each axle requires before installing.









