Overview
The Omix-ADA shifter boot ring, part 18880.28, is a rubber ring for the T90 shifter boot. It fits Jeep and Willys models from 1946 to 1971, mostly CJ-series vehicles, along with several J-series trucks and the Wagoneer SJ.
The ring holds the shifter boot in place around the shift lever, keeping dirt and water out of the floor opening.
Key features
- Rubber construction
- Replacement ring for the T90 shifter boot
- Built to original Jeep specifications
Shifter boot and floor seal
The shifter boot sits between the floor opening and the shift lever, and the ring holds its edge tight against the floor so dirt and water stay out. A loose ring lets the boot lift and rattle, and cracked rubber can let debris into the transmission tunnel.
Rubber rings harden and shrink with age and exposure to heat and sun. When replacing the ring, clean the floor opening and check the boot for tears. Keeping the boot seated correctly helps protect the shifter linkage from grit and moisture, which is especially useful on older vehicles that are driven off road.
- Check the boot for tears or hardened spots
- Clean the floor opening before fitting
- Replace the ring if it no longer holds the boot flat
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18880.28 |
| Component | T90 shifter boot ring |
| Material | Rubber |
| Warranty | It carries a limited five-year warranty. |
Vehicle fitment
It fits 1946 through 1971 Jeep and Willys models, mostly CJ-series vehicles, plus Jeepster, Wagoneer SJ, Gladiator and J-series trucks.
Vehicles from the 1972 model year on are not in the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rubber shifter boot ring.









