Overview
The Omix-Ada 17410.02 is a push rod for 1972 to 1977 Jeep CJ5, CJ6, CJ7, Cherokee SJ, Wagoneer SJ and J-series trucks, plus the 1972 to 1973 Commando.
It is a direct OE replacement built to original Jeep specifications. Compare the rod against the one you remove before installing it, to confirm length and fit.
Key features
- Direct OE replacement push rod
- Built to original Jeep specifications.
- Covers CJ, Cherokee SJ, Wagoneer and J-series models
- Part number 17410.02 and UPC 804314025380
Comparing the old rod
A push rod that has been in service for decades may have worn ends, a bent shaft or a loose fit in the lifter cup. Removing the old rod first lets you check these points. Lay the old and new rods side by side and compare length, end shape and the diameter of the shaft. Any difference in length will change valve action, so this comparison is worth the time.
If the old rod looks worn, the lifter and rocker arm it touched may be worn too. Check the lifter face and the rocker tip for flat spots or pitting. Lubricate the rod ends during assembly and make sure the rod sits fully in both sockets before tightening the rocker hardware. Recheck valve clearance after the engine has run for a while.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17410.02 |
| UPC | 804314025380 |
| Type | Push rod |
| Fitment | Direct fit |
Vehicle fitment
It fits 1974 to 1977 Cherokee SJ (Base, S), 1972 to 1977 CJ5 (Base, Golden Eagle, Renegade), 1972 to 1975 CJ6 (Base), 1976 to 1977 CJ7 (Base, Golden Eagle, Renegade), 1972 to 1973 Commando, 1972 to 1974 DJ5, 1972 to 1973 J-2500 and J-2600, 1974 to 1977 J10, 1974 and 1976 J20, and 1972 to 1973 Wagoneer SJ (Base, Custom).
No model in this list runs past 1977. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One push rod.
Not included: Confirm the quantity needed for your engine before ordering.









