Overview
The Omix-ADA 18014.03 is a power steering pressure hose for 1980–1981 Jeep CJ5 and CJ7 models. It runs between the steering gear and the power steering pump and is built to original specifications as a direct replacement.
It fits the CJ5 and CJ7 trims shown in the fitment section below and is made for the 304 V8 engine.
Key features
- Direct replacement design built to original specifications
- Gear-to-pump position for the power steering pressure line
- Fits the 304 V8 engine.
- Manufacturer-listed direct fit for 1980–1981 CJ5 and CJ7
Gear-to-pump routing on a CJ
On a CJ with a 304 V8, the power steering lines run through a crowded area near the exhaust manifold, the steering linkage and the frame rails. Heat and movement are the main causes of hose wear in this location, so the rubber can harden or chafe where it passes close to metal. Checking the route before fitting helps the new hose stay clear of hot and moving parts for its full service life.
When replacing the gear-to-pump hose, look at the pump outlet, the gear end and any clamps or tie straps that hold the line. Avoid sharp bends and low sagging spots where fluid can collect, and make sure the hose does not rub at full steering lock. Recheck the routing after the first drive, since the line can settle slightly as the fluid system warms up.
- Keep the line clear of the exhaust manifold
- Check clearance at full steering lock
- Replace worn tie straps and clamps
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18014.03 |
| UPC | 804314036867 |
| Hose type | Power steering pressure hose |
| Position | Gear to pump |
| Fitment type | Direct fit |
| Engine | 304 V8 |
Vehicle fitment
It fits the 1980–1981 Jeep CJ5 (Base, Golden Eagle, Laredo, Renegade) and 1980–1981 Jeep CJ7 (Base, Golden Hawk, Laredo, Renegade).
Cherokee, Wrangler and other Jeep generations fall outside this fit. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package contains one power steering pressure hose. Check your existing clamps and hose ends before installation.









