Overview
The Omix-Ada 18677.01 is a speedo gear for the NP241 transfer case, part number 18677.01. It is used when the speedometer needs to read correctly after tire size or axle gear ratios change, since the stock gear then reads higher or lower than actual speed.
Use a tire and gear ratio chart to choose the right tooth count for your setup.
Key features
- Speedo gear for the NP241 transfer case
- It is a direct fit for the NP241 transfer case.
- Helps restore accurate MPH after tire or axle ratio changes
- Replacement speedometer drive gear from the Omix-Ada line
Speedo gears and tire changes
A speedo gear is a small driven gear that turns in step with the output of the transfer case, and its tooth count sets how many signal pulses are sent per revolution. A change in tire size or axle ratio alters the rate at which the transfer case spins compared to road speed, so the gear’s count must be matched to keep the MPH accurate.
Because a tire change is the most common reason for a speedo gear swap, compare the old and new tire diameters first, then work through a tire and gear ratio chart. Keep the original gear until the new reading is confirmed, and check the reading at a steady speed after fitting. Teeth that are cracked or worn should be replaced even if the tooth count is correct.
- Measure the new tire diameter
- Note the axle gear ratio
- Keep the original gear until the reading is confirmed
- Replace any gear with cracked or worn teeth
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18677.01 |
| UPC | 804314029395 |
| Transfer case | NP241 |
Vehicle fitment
The NP241 transfer case is the main fit check for this gear.
Check your transfer case, then confirm your vehicle’s year, model and trim before ordering.
Installation notes
Work out the tooth count against your tire size and axle ratio before fitting.
What’s included
Review the package contents against your installation before starting.









