Overview
The Omix-ADA 12023.28 is a footman loop in a silver finish, part of the CJ2A, 3A and 3B replacement body parts range. It fits the 1959 Jeep CJ3 and the 1946 to 1958 Willys CJ-2 and CJ-3.
Omix-ADA builds its Jeep parts as direct OE replacements to the original specifications and provides a limited five year warranty. A footman loop is a small body-mounted loop used to hold a soft top or similar fabric strap.
Key features
- Footman loop in a silver finish
- Replacement body part for CJ2A, 3A and 3B models
- Direct OE replacement built to the original specifications
- Limited five year warranty
- Direct fit part
Mounting and clearance
A footman loop is a body-mounted loop, so its job depends on sitting square against the body and holding its position under a strap or fabric load. Before final tightening, set the loop where it sits level with its mounting area and clear of neighboring parts. A loop that sits crooked can pull on its fasteners and wear the surrounding metal over time.
Clean the mounting area and remove loose rust or old sealant so the new loop seats properly. Choose fasteners that suit the metal, and avoid mixing hardware types that could loosen or corrode. Check that the loop does not interfere with doors or the top when they close, and recheck its position after the first drives.
- Clean and dry the mounting surface
- Test fit before final tightening
- Check clearance with the top and doors
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 12023.28 (OAI12023.28) |
| Part type | Footman loop |
| Finish | Silver |
| Category | CJ2A, 3A and 3B replacement body parts |
| Fit type | Direct fit |
| Warranty | Limited five year warranty |
Vehicle fitment
It fits the 1959 Jeep CJ3 (Base), the 1946 to 1949 Jeep Willys CJ-2 and the 1949 to 1952 and 1954 to 1958 Jeep Willys CJ-3. Compare part number 12023.28 (OAI12023.28) and the UPC, when one is shown, to confirm you have the same item, since parts from the same maker can differ by vehicle, year or position. Confirm fit for your vehicle’s year, model and trim before ordering.
The list does not include 1953 CJ-3 models, the CJ-5 or later Jeeps. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Follow the installation instructions in the vehicle service manual and tighten all fasteners to the specifications for your model. Check that the loop lines up with the existing mounting holes on the body, and use fasteners that suit the metal. Re-check fasteners after the first miles of driving. Test fit the part before final tightening, and check clearance with doors, the hood, the tailgate and moving parts. Protect paint and trim with masking tape or a soft cover during installation, and use only the hardware suited to the loop. Re-check the attachment periodically afterwards.










