Overview
The Omix-Ada OAI12025.35 is a steel driver side front top bow bracket with a black primer finish. It fits the 1946–1949 Jeep Willys CJ-2 and the 1949–1952 Jeep Willys CJ-3.
It replaces the original front bracket on the driver side of a CJ-2 or CJ-3 top bow. It is a direct OE replacement built to original specifications.
Key features
- Driver side front location
- Steel construction
- Black primer finish
- Direct OE replacement
- Limited five year warranty.
Top bow hardware and fit
A top bow bracket carries the load of the bow and holds it in position when the top is raised. On a CJ-2 or CJ-3 the bracket sits near the front of the frame, where movement, road vibration and moisture can loosen fasteners and wear the mounting area. Check the bracket before fitting the top.
Test-fit the bracket against the bow and frame before final tightening. Make sure the bow lines up square and that the top can be raised and lowered without binding. Steel brackets with primer finish usually need a coat of paint after installation to protect exposed edges.
Because the driver side and passenger side bows share a load path, it is worth inspecting the opposite bracket and bow at the same time. Replacing both at once keeps the top balanced.
- Check for cracks, bends and rust
- Inspect bolt holes for elongation
- Confirm the bow lines up square
- Repaint exposed edges after fitting
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI12025.35 |
| Location | Driver side, front |
| Material | Steel |
| Finish | Black primer |
| Quantity | One bracket |
| Vehicle years | 1946–1952 Jeep Willys CJ-2 and CJ-3 |
| Warranty | Limited five year warranty |
Vehicle fitment
It fits the 1946–1949 Jeep Willys CJ-2 and the 1949–1952 Jeep Willys CJ-3.
CJ-5 and CJ-7 models and other Willys models are not covered. Confirm your year, model and trim before buying.
What’s included
The entry describes one driver side front bracket.
Not included: Check the mounting hardware you need before starting the installation.









