Overview
The Omix-Ada 11603.07 is a left-side fender flare extension for the 2004–2006 Jeep Wrangler LJ and the 1997–2006 Jeep Wrangler TJ. It carries part number OAI11603.07 and is a direct fit for the models below.
The extension is made from UV-treated thermoplastic, which Omix-Ada describes as durable and built for years of service. It is a separate piece that attaches to the flare system, so it can be replaced by itself.
Compare the extension with the existing piece before installing it to confirm the match.
Key features
- Left-side extension
- UV-treated thermoplastic construction
- Direct fit for the listed LJ and TJ models
- Separate piece, not a complete flare
Seams, sealing and extension care
The seam where an extension meets the flare is the main place water, mud and grit get in. A good seam sits flush along the edge with no gaps, and any gap should be checked before the fasteners are fully tightened. Look for dried sealant, split clips or edge lift after trail use, since these are early signs the piece is moving on its mounts.
Clean the extension with mild soap and water, and avoid harsh solvents on the surface. Check the fasteners after the first few trail runs, and tighten them gradually rather than all at once. When a left extension is replaced, compare its color and edge line with the right side, because sun exposure over time can shift shade on plastic parts.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 11603.07 (also written as OAI11603.07) |
| UPC | 804314058197 |
| Position | Left |
| Material | UV-treated thermoplastic |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler LJ, including the Unlimited and Unlimited Rubicon trims, and the 1997–2006 Jeep Wrangler TJ, including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
It is made for LJ and TJ models. Compare your vehicle’s year, model and trim before buying.
What’s included
One left-side fender flare extension.









