Overview
The Omix-ADA AX15 1st and 2nd gear synchronizer ring, part 18887.26, is a brass-style replacement ring for the AX15 transmission. It fits the 1988–1995 Jeep Wrangler YJ and the 1997 Wrangler TJ Sport.
Synchronizer rings help match the speed of the gears before they engage, so worn rings make shifting notchy. This is the original-specification replacement for the first and second gear positions.
Key features
- Brass-style ring for the AX15 first and second gear
- 36 teeth and three alignment notches
- 3/8 inch thick
- Built to the original Jeep specifications
Signs the rings are worn
Worn synchronizer rings usually show up as grinding or hard shifts into first or second gear, especially when the transmission is cold. The cone faces wear smooth over time, which cuts the friction needed to match gear speeds before engagement. Before installing new rings, inspect the synchronizer hubs and sleeves, because a worn hub can wear a new ring quickly.
Clutch condition matters too. A clutch that slips or drags adds load to the synchronizers and can shorten their life. Use a gear oil that suits the AX15 and change it on schedule, since contaminated fluid can glaze the cone surfaces. Replacing the rings in pairs with the hubs inspected keeps shift feel even between gears.
When the transmission is apart, clean all parts thoroughly and check the gear teeth for chips before reassembly. Small debris left in the case can lodge in the synchronizers and cause early failure.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18887.26 |
| Transmission | AX15 |
| Engine | 4.0-liter six-cylinder |
| Ring style | Brass, three alignment notches, 36 teeth |
| Thickness | 3/8 inch |
| Warranty | Limited five-year warranty. |
Vehicle fitment
It fits the 1997 Jeep Wrangler (TJ) Sport and the 1988–1995 Jeep Wrangler (YJ) models.
Other Wrangler years and transmissions are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Synchronizer rings are normally replaced with the transmission apart, and the cone surfaces should be checked for wear before the new ring goes in.
What’s included
Quantity two is required per transmission, so two rings are needed for the install.









