Overview
The Omix-Ada 11609.01 is a four-piece paintable fender flare kit for the front and rear of two-door and four-door Jeep models. Its alternate part number is OAI11609.01, and the set covers four flares at stock width.
The flares are made of UV-treated thermoplastic that Omix-Ada describes as virtually indestructible, durable and built for years of service. Each replacement flare is designed to fit the factory mounting holes, which Omix-Ada says allows for ease of installation.
The kit requires no drilling. Mounting hardware is not included. Single replacement flares are sold for owners who need only one.
Key features
- Four-piece kit for front and rear
- Designed for two-door and four-door Jeep models
- UV-treated thermoplastic construction
- Designed to fit the factory mounting holes
- No drilling required
- Paintable finish
Before you install
Fender flares cover the wheel openings and help keep tires from throwing mud, sand and loose debris onto the body and windows. On a Jeep, they are often fitted when the tires are wider than the stock opening or when a lift has changed how the wheels sit in the arch. They also shield the edge of the paint, where stones and grit tend to strike first.
Plastic flares flex more than steel and react to heat and sun, so handle them carefully and inspect them before fitting. Clean the mounting surfaces and check the factory clips and bolts for corrosion, since rusted hardware is the most common reason a flare sits unevenly. If a flare does not sit flush, loosen the fasteners and reseat it instead of forcing it into position.
- Test-fit each flare before any painting
- Replace corroded clips or bolts
- Check tire clearance at full steering lock
- Inspect mounting edges for cracks after rough trails
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 11609.01 (alternate number OAI11609.01) |
| UPC | 804314174910 |
| Quantity | Set of 4 |
| Position | Front and rear |
| Width/coverage | Stock |
| Finish | Paintable |
| Material | UV-treated thermoplastic |
| Hardware | Not included |
| Fitment type | Direct fit |
Vehicle fitment
It is designed for two-door and four-door Jeep models. Match the year, model and trim of your vehicle before ordering, since no specific Jeep model name or years are given for this kit.
Match the year, model and trim of your vehicle to the kit before ordering, then compare the fit against your body.
Installation notes
The kit requires no drilling. Mounting hardware is not included, so the factory hardware is reused. If that hardware is rusted, some hole modification may be needed.
What’s included
A four-piece set of replacement fender flares.
Not included: Mounting hardware.









