Overview
The N-Fab Off-Road Light Bar, part number T1630OR, is a gloss black powder coated steel light bar built for a 30 in LED light. N-Fab makes nerf bars, pre-runners and other off-road accessories, and this bar uses the same tubular construction.
The bar is made of .084 wall steel, welded in one piece and zinc coated for corrosion protection. It is a direct fit design with no vehicle named, and license plate mounting tabs are not included.
Key features
- Made for use with a 30 in LED light
- Gloss black powder coat
- .084 wall steel
- All welded one piece construction
- Zinc coated for corrosion protection
- Direct fit listing without named vehicles
Wiring and mounting tips
Off-road light bars carry their weight at the front or top of a vehicle, so the mounting points matter as much as the light. A steel bar of this type is usually bolted to a bumper, roll bar or light tower, and the weight and vibration of trail use put steady stress on every fastener. Before installing, check that the chosen mounting surface is solid and free of rust, and plan to re-check the fasteners after the first several trail runs.
Wiring deserves the same care. Run leads away from moving parts and hot exhaust components, use a relay where the current draw warrants it, and keep a fuse close to the battery. Mud and water can work into connectors, so use sealed connectors and dielectric grease where possible. Set the aim on level ground and re-check it after bumps or hard landings, since a misaimed bar wastes output.
- Inspect welds and brackets for cracks after rough trail use
- Re-tighten fasteners on a regular schedule
- Keep the lens clean for full output
Specifications
| Brand | N-Fab |
|---|---|
| Part number | T1630OR |
| Light size | 30 in LED |
| Finish | Gloss black powder coat |
| Material | Steel, .084 wall |
| Construction | All welded one piece |
| Corrosion protection | Zinc coat |
| Mounting tabs | License plate tabs not included |
| Fitment | Direct fit, no vehicles named |
Vehicle fitment
It is a direct fit bar, but no vehicle years, models or trims are named, so fit is not confirmed for any specific vehicle.
Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Plan your own mounting method, since license plate mounting tabs are not included. Confirm the 30 in LED light matches the bar, and wire the light through a fuse close to the power source.
What’s included
No hardware is included with the bar.
Not included: License plate mounting tabs and the 30 in LED light.









