Overview
The N-Fab Cab Length Nerf Step Bars, part number N/FD9773QC-TX, are textured black tubular nerf step bars for 1997–2001 Dodge Ram 1500, 2500 and 3500 pickups. Nerf bars, also called side steps, give you a step up into the cab and a steel bar along the side of the truck.
N-Fab describes its nerf bars and pre-runner accessories as heavy duty tubular parts built for trucks and SUVs dating back to the 80s. This cab length version is a direct fit for the Ram models in the fitment section below and uses the .084 wall steel and all-welded build covered in the features.
Key features
- All-welded one-piece construction
- Heavier gauge .084 wall steel tubing
- Zinc coated for corrosion protection
- Powder-coated finish in textured matte black.
- Cab length design with direct fit
Installation prep for Ram owners
Before fitting any side step to a Ram, look over the frame mounting points and the cab floor area for rust or prior damage. Solid metal gives the brackets a firm base, while soft or flaking metal can fail under body weight. Clean the contact areas down to bare metal and apply a light coat of protective primer before bolting anything on.
Heavy-duty trucks carry more weight at the rear, so the steps should be set so they clear the rocker panels and the tire. Test the fit by stepping on the bar at the position where you would normally enter. A bar that flexes or shifts under light load needs its brackets checked again.
Use new fasteners of the correct grade rather than reusing old hardware. Tighten in a sequence that pulls the bracket evenly against the body, and recheck torque after the first few days of driving.
- Clean contact areas to bare metal
- Apply protective primer before assembly
- Use new fasteners of matching grade
- Recheck tightness after the first week
Specifications
| Brand | N-Fab |
|---|---|
| Part number | N/FD9773QC-TX |
| Finish | Textured/Matte Black |
| Length | Cab Length |
| Fit type | Direct fit |
| Steel wall | .084 wall steel |
| Construction | All-welded one-piece |
| Coating | Zinc coated, powder-coated |
Vehicle fitment
It fits the 1997–2001 Dodge Ram 1500 in Laramie, ST, Sport and WS trims, the 1997–2001 Dodge Ram 2500 Base, and the 1998–2001 Dodge Ram 3500 Base.
Ram models newer than the 2001 model year are not on this list, and the 1997 Ram 3500 is not included either. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation steps before starting.









