Overview
The Mountain Off Road Enterprises SH300 is a set of long travel front shock brackets for the Jeep YJ front, made from bare steel. The brackets allow a longer front shock for more wheel travel and convert the shock to a loop-style top mount.
Installation begins by cutting the stock shock tower. The hoop then bolts to the existing hole on the back side of the tower, and welding may be needed in some cases.
Key features
- Designed for the Jeep YJ front
- Allows a longer front shock for more wheel travel
- Converts the shock to a loop-style top mount
- Bare steel construction
- Bolts to the existing hole in the back of the stock tower
Longer shocks and travel
Longer front shocks let the axle reach further before the shock bottoms out, which adds wheel travel on uneven ground. The longer shock also changes the angle and leverage at the mount, so the bracket geometry and the shock’s stroke should be checked together before the setup is driven on the street. Upgraded springs or a different track setup are often considered at the same time, since they change ride height and shock angle.
Because the stock tower is cut, the bracket becomes a structural point, so inspect the welds and the bolted hoop after the first few trail runs for cracks or movement. Steering and brake lines, the fender and the tire clearance at full compression should also be checked, since added travel can change where they sit.
- Check tire clearance at full compression
- Inspect welds and hoop bolts after trail use
Specifications
| Brand | Mountain Off Road Enterprises |
|---|---|
| Part number | SH300 |
| UPC | 815572021045 |
| Material | Bare steel |
| Position | Front |
| Mounting location | Frame side mounting. |
| Shock style | Loop-style top mount conversion |
| Vehicle | Jeep YJ |
Vehicle fitment
The brackets are designed for the Jeep YJ front and mount on the frame side. Check the mounting against your tower before cutting.
The bracket is built for the YJ front, so confirm your vehicle’s year, model and trim before ordering.
Installation notes
The stock shock tower must be cut, and welding may be necessary in some cases, so plan for a cut-and-fit job rather than a bolt-on swap. Cutting and welding the tower throws sparks and heat, so wear eye and hand protection.
What’s included
The brackets are bare steel units.
Not included: Check the package contents against your installation before starting, and plan for longer shocks separately.









