Overview
The Misch 4×4 Big Boy Seat Bracket, passenger side (part MSCJBBJK350P), is a seat bracket for 2011–2018 Jeep Wrangler JK 2-door trims. Misch designed its BigBoy brackets to add leg room from the stock seat position, and Misch says they add 3 inches.
Installation does not require drilling or modifications to the seat or floor, and Misch gives an installation time of approximately 10-15 minutes per seat. The driver side bracket is sold separately under part MSCJBBJK350D.
Key features
- Passenger side seat bracket
- Adds 3 inches of leg room from the stock seat position
- No drilling or modifications to the seat or floor
- Made in the USA
- Sold individually
Planning a seat bracket install
Swapping a seat bracket is one of the more manageable seat-position upgrades, since the bolts and mounting points stay largely in the same place. Before starting, lay out the bolts and check that the new bracket sits level against the stock seat base. Working with a helper makes it easier to line up the seat and hold it while the fasteners are started.
After installation, test the seat over its full travel and check that it locks in every position. Recheck the bolt torque after the first few drives, since new brackets can settle. If you change one side, match the other side’s position so the seat feels even.
- Work on a level surface with the seat removed
- Confirm the seat locks at each track position
- Replace any bolt that shows stretching or rust
Specifications
| Brand | Misch 4×4 |
|---|---|
| Part number | MSCJBBJK350P |
| Position | Passenger side |
| Type | Seat bracket |
| Leg room gain | 3 inches |
| Drilling | Not required |
| Installation time | Approximately 10-15 minutes per seat |
| Country of manufacture | USA |
Vehicle fitment
The bracket fits 2011–2018 Jeep Wrangler (JK) 2-door trims: 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport and Sport S.
Four-door JK Unlimited models are outside this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bracket bolts in without drilling, so the seat and floor stay unchanged. Plan for about 10-15 minutes per seat, and keep both driver and passenger brackets matched if you change both sides.
What’s included
One passenger side seat bracket, sold individually.
Not included: The driver side bracket, part MSCJBBJK350D, is a separate purchase.










