Overview
The Lange Originals 020-298 Kwick Kit is a hardtop removal system for factory hardtops. It uses two adjustable quick-release latches on the windshield frame and eight patented 1-1/4 turn fasteners so the top can be taken off and put back on with minimal loose hardware.
The nut portion of each fastener attaches permanently to the body, so the removal hardware stays with the vehicle. Twist the fasteners to reinstall the top, and they hold it snug. The kit also includes 4 rear latches for the TJ version, which need no drilling. It will not work with fiberglass bodies.
Key features
- Two adjustable quick-release latches for the windshield frame
- Eight patented 1-1/4 turn fasteners that remove easily
- Nut portion of each fastener stays attached to the body
- 4 rear latches for the TJ version that need no drilling
- Complete instructions included
Drilling and fastener fit
Drilling and pop riveting are the least forgiving parts of this kind of install. Mark each hole position with the hardtop seated and aligned, and check the marks from more than one angle before drilling. A small offset at the windshield frame can make the quarter-turn fasteners hard to seat later.
Test fit the latches and fasteners before final tightening. Use a clean bit that suits the metal, and deburr holes so the rivets sit flat. Keep fiberglass bodies out of this job, since the kit is not meant for them. Finish with a check that the top lifts off and reseats without binding.
- Mark hole positions with the top seated
- Deburr holes before riveting
- Test fit before final tightening
Specifications
| Brand | Lange Originals |
|---|---|
| Part number | 020-298 |
| UPC | 859711004124 |
| Windshield latches | Two, adjustable, quick-release |
| Fasteners | Eight patented 1-1/4 turn fasteners |
| Rear latches | 4, TJ version, no drilling required |
| Body type | Factory hardtops only; not for fiberglass bodies |
Vehicle fitment
The kit is for factory hardtops, and the rear latches are made for the TJ version. Check your vehicle’s year, model and trim before ordering.
Check your hardtop’s year, model and trim before installing the latches.
Installation notes
Some drilling is needed, and a pop rivet tool is required for installation. Read the complete instructions included with the kit before starting.
What’s included
Two adjustable quick-release windshield latches, eight 1-1/4 turn fasteners with the nut portions that attach to the body, 4 rear latches for the TJ version, and complete instructions.
Not included: The pop rivet tool needed for installation.









