Overview
The Kentrol 30438 stainless steel bumperettes are a pair of 304 stainless steel bumper end guards that mount into the factory crossmember holes. Kentrol includes stainless hardware with the pair.
Kentrol says no drilling is required except on the rear frame crossmember of 1998-and-newer TJ Wranglers. The company describes its stainless products as virgin 304 stainless steel that does not rust easily and keeps a mirror-like shine with an occasional waxing.
Key features
- Pair of stainless steel bumperettes
- Made of 304 stainless steel
- Stainless hardware included
- Mounts into the factory crossmember holes
- Direct-fit design
Before you buy
Bumperettes are short bumper end guards that protect the corners of a front or rear bumper from contact in tight trail spots and parking lots. They are a smaller step than a full bumper, so they suit owners who want corner protection without the weight and cost of a complete bumper system.
Check your mounting points before you order. These bumperettes bolt into factory crossmember holes, so the existing holes and the condition of the crossmember matter more than the part itself. Inspect the crossmember for rust, and make sure the hardware fits the holes you already have. Re-check the fasteners after the first few drives, especially if the vehicle sees rough roads.
- Inspect the crossmember for rust before mounting
- Confirm the factory holes are clean and undamaged
- Re-check fasteners after the first few drives
Specifications
| Brand | Kentrol |
|---|---|
| Part number | 30438 |
| UPC | 812421020433 |
| Product type | Bumperettes, sold as a pair |
| Material | 304 stainless steel |
| Finish | Stainless steel |
| Hardware | Stainless steel, included |
| Mounting | Factory crossmember holes |
| Receiver hitch | No |
| Tire carrier | No |
| D-ring mounts | Not included |
Vehicle fitment
Drilling is needed only at the rear frame crossmember of 1998-and-newer TJ Wranglers.
Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The bumperettes mount into the factory crossmember holes with no drilling, except at the rear frame crossmember of 1998-and-newer TJ models, where drilling is required.
What’s included
A pair of 304 stainless steel bumperettes with stainless steel hardware.









