Overview
The Addictive Desert Designs Stealth Fighter rear bumper with sensors, part ADSR681241280103, is a low profile steel plate rear bumper for the 2016–2023 Toyota Tacoma. It fits the rear of the truck closely, which keeps the bumper from adding bulk to the Tacoma.
Two rear-facing cube light mounts come standard with the bumper. Integrated reinforced clevis mounts accept a 3/4-inch D-ring for recovery, and the sensor cutouts keep the factory parking sensors working.
The bumper is finished in powder coat and is a direct fit for the 2016–2023 Toyota Tacoma. It replaces the factory rear bumper on that truck.
Key features
- Low profile steel plate design that adds no bulk to the Tacoma
- Two rear-facing cube light mounts, standard
- Integrated reinforced clevis mounts for 3/4-inch D-rings
- Sensor cutouts for the factory parking sensors
- Powder coat finish
Before you install
A rear bumper does more than protect the tailgate area. On a Tacoma it sits close to the hitch, the backup sensors and the wiring that runs to the lights, so fit and mounting points matter before any trail use. Low profile bumpers reduce the overhang that can catch on ledges, but the mounts still carry the load of any recovery, so inspect the welds and bolts regularly, especially after a hard hit.
Light wiring is worth planning before the bumper goes on. Route the harness away from moving parts and sharp edges, and use the existing grommets where possible. If you add a hitch or cargo carrier later, check that it clears the bumper and the sensor cutouts. Powder coat holds up well to daily use, but chips near the mounts should be touched up to slow rust on the steel.
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Part number | ADSR681241280103 |
| Position | Rear |
| Material | Steel plate |
| Finish | Powder coat |
| Light mounts | Two rear-facing cube light mounts, standard |
| D-ring mounts | Included, integrated reinforced clevis mounts for 3/4-inch D-rings |
| Sensor cutouts | Included |
| Tire carrier | Not included |
| Installation type | Direct fit |
Vehicle fitment
This bumper fits the 2016–2023 Toyota Tacoma.
Only the 2016–2023 Tacoma is covered by this bumper. Confirm fit for your model year and trim before ordering.
What’s included
The low profile steel rear bumper with its two rear-facing cube light mounts, integrated reinforced clevis mounts and sensor cutouts.
Not included: Cube lights, LED light bars and D-ring shackles.
















