Overview
The Jeep 4338910 is a transfer case input gear snap ring, a factory replacement part sold under the Jeep brand and identified by part number 4338910. It is a retaining ring for the input gear inside the transfer case.
The part number 4338910 and UPC 700007618381 identify it. Confirm fit for your year, model and transfer case before ordering.
Snap rings and the input gear
A snap ring holds a gear or bearing in place on its shaft, keeping the parts from moving out of position under load. In a transfer case, a worn or distorted ring can allow a gear to walk, creating noise or contact damage. Replacing a worn ring is a small job that protects the gear around it.
Snap rings should seat fully in their groove. Remove the old ring carefully, check the groove for burrs or wear, and inspect the gear for marks where the ring bore against it. Use a ring that matches the groove and the shaft, and avoid reusing a ring that has been stretched or bent.
Snap rings are often replaced with other input-side parts when the case is opened. Inspect the bearings and the input gear teeth before closing the case.
- Check the groove for burrs or wear
- Do not reuse a bent or stretched ring
- Inspect the input gear teeth
Specifications
| Brand | Jeep |
|---|---|
| Part number | 4338910 |
| UPC | 700007618381 |
| Part type | Transfer case input gear snap ring |
Vehicle fitment
Compare the ring with the one you removed and confirm fit for your year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.









