Overview
The Hyline Offroad louvered hood panel, part number 400.500.120, is a hood panel for the 2007 to 2016 Jeep Wrangler JK and is a direct fit for those models. It is built for 2 and 4-door models and gives the hood a louvered look with a single windshield nozzle.
Flush head threaded studs are already pressed into the panel, so the finished surface stays smooth. Installation uses a precision laser cut metal template: lay it on the hood, then drill and cut the holes. The panel is made in the U.S.A. from 5052 aluminum and comes either unpainted, ready for your own finish, or with a smooth black semi gloss powder coat.
Key features
- Louvered hood panel with a single windshield nozzle
- Flush head threaded studs pressed into the panel
- Precision laser cut metal template included for marking holes and cuts
- Made from 5052 aluminum
- Black semi gloss powder coat or unpainted finish
- Designed for 2 and 4-door models
- Made in the U.S.A.
Preparing a louvered hood
A louvered panel changes how air and heat move across the front of the hood, and the opening sets the look of the whole front end. Before cutting, mark all holes and cuts with the template and check them from above and from the sides. Aluminum panels can be marked with a fine pen, and a center punch helps keep drill bits from wandering.
Aluminum scratches easily and leaves sharp edges after cutting, so deburr every cut edge and clean away filings before fitting the panel. Keep the hood insulation and any wiring clear of the cutting zone. After installation, confirm the panel and studs sit flat, then recheck the fasteners after the first few drives.
- Mark every hole with the template first
- Deburr edges and remove filings
- Keep wiring and insulation clear of cuts
- Check fasteners after the first drives
Specifications
| Brand | Hyline Offroad |
|---|---|
| Part number | 400.500.120 |
| UPC | 700007609321 |
| Material | 5052 aluminum |
| Finish | Black powder coat (smooth, semi gloss) or unpainted |
| Nozzles | Single windshield nozzle |
| Door configuration | 2 and 4-door models |
| Stud type | Flush head threaded studs, pre-pressed into the panel |
| Included | Precision laser cut metal template |
| Origin | Made in the U.S.A. |
Vehicle fitment
It fits the 2007–2016 Jeep Wrangler (JK), covering the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, along with the Unlimited versions of those trims.
It fits the JK generation only, not the JL generation or the earlier TJ and LJ Wrangler models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Cutting and drilling are required, so the template must be positioned exactly before any holes are made. Wear eye protection when cutting the metal hood panel.
What’s included
The hood panel with flush head threaded studs already pressed in, and the precision laser cut metal template.
Not included: Cutting and drilling tools, which the installation requires.









