Overview
The Gorilla Whips 4 LED Xtreme Whip with Wireless Remote (model LEDREM1004) is a 4 foot LED whip with over 140 LEDs for ATVs, RZRs, dune buggies, sand rails and UTVs. Its LEDs change among 20 colors and 19 settings from a pre-synced wireless remote.
It is not tied to one vehicle model, so the mounting point and wiring route on your vehicle decide where it goes. The quick release billet aluminum mount lets you move the whip between machines.
Key features
- Over 140 LEDs in a 4 foot whip
- 20 built-in colors and 19 customizable settings
- Wireless remote pre-synced to this whip, and it can also sync with other Gorilla Whips LED Xtreme Whips and Undermount kits
- 40 in quick release wire harness
- 2 quick connect wire splicers
- Quick release billet aluminum mount with quick release pin
Before you wire it up
Light bars and whips mounted on off-road machines see constant vibration and occasional impact from brush and trail debris. The mounting hardware should be checked periodically, especially the bolt and lock washer that secure the base, and tightened if any movement shows up. A quick release mount is handy for removing the whip when you leave the trail or transport the vehicle.
Wiring is where most problems start. A stable power source with proper fusing protects the electrical system, and a relay keeps current away from the switch circuit. Route the harness away from moving suspension parts, sharp edges and hot exhaust components, and secure it with loom or clips so it does not chafe.
Think about how the whip will be controlled before you install it. A wireless remote is convenient for changing modes on the trail, but it depends on a clear line of use and its own battery attention. Check local rules on whip lights, since some areas restrict them on public roads.
Specifications
| Brand | Gorilla Whips |
|---|---|
| Model number | LEDREM1004 |
| UPC | 700007450301 |
| Length | 4 ft |
| LEDs | Over 140 |
| Colors | 20 |
| Settings | 19 |
| Wire harness | 40 in, quick release |
| Wire splicers | 2, quick connect |
| Hardware | 1-1/2 in bolt, nut, washer and lock washer |
| Mount | Quick release billet aluminum with quick release pin |
| Control | Wireless remote, pre-synced |
Vehicle fitment
It is a universal fit for ATVs, RZRs, dune buggies, sand rails and UTVs, with no single vehicle model required. Check the mounting point on your vehicle before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Wire the harness through a fused circuit, preferably with a relay, and join it with the quick connect splicers. Check local rules before running the whip on public roads.
What’s included
One 4 ft LED whip with wireless remote, 40 in quick release wire harness, 2 quick connect wire splicers, 1-1/2 in bolt, nut, washer and lock washer, and 1 quick release billet aluminum mount with quick release pin.













































