Overview
The Gorilla Whips 3 LED Xtreme Whip with Wireless Remote (model LEDREM1003) is a 3 foot LED whip with over 105 LEDs for off-road vehicles. Its LEDs change among 20 colors and 19 settings through a pre-synced wireless remote.
It is a universal fit and can be used on Jeeps, trucks, ATVs, RZRs, dune buggies, sand rails and UTVs. It is for off-road use only and includes an orange pennant flag.
Key features
- Over 105 LEDs in a 3 foot whip
- 20 colors and 19 customizable settings
- Pre-synced wireless remote that can also control other Gorilla Whips LED Xtreme Whips
- Orange pennant flag included
- Quick release billet aluminum mount with quick release pin
- Labeled for off-road use only
Off-road use and local rules
Off-road lighting is typically used on trails, in camp, or for visibility during night runs in open terrain. Because the whip is intended for off-road use, keep it off public roads unless local rules allow it. Confirm the rules where you ride, since enforcement and allowances vary by area.
Flags and whips add height and can catch branches, so mount them with the flag clear of low obstacles. Check the flag and mount after rough sections, and keep the pennant secured so it does not come loose on the trail.
- Check local rules before using the whip on public roads
- Keep the flag clear of branches and overhead hazards
- Inspect the mount after rough terrain
- Store the whip out of direct sun when not in use
Specifications
| Brand | Gorilla Whips |
|---|---|
| Model number | LEDREM1003 |
| UPC | 852451006021 |
| Length | 3 ft |
| LEDs | Over 105 |
| Colors | 20 |
| Settings | 19 |
| Wire harness | 40 in, quick release |
| Wire splicers | 2, quick connect |
| Hardware | 1 1/2 in bolt, nut, washer and lock washer |
| Mount | Quick release billet aluminum with quick release pin |
| Flag | Orange pennant |
| Intended use | Off-road use only |
Vehicle fitment
It is a universal fit, so no specific vehicle or year applies. Jeeps and trucks are among the typical uses, not a fitment list.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Connect the 40 in harness with the two quick connect splicers and run it to a fused power source. Secure the whip with the quick release mount and pin. Check local rules before using an off-road-only whip on public roads.
What’s included
One 3 ft LED whip with pre-synced wireless remote, orange pennant flag, 40 in quick release wire harness, 2 quick connect wire splicers, 1 1/2 in bolt, nut, washer and lock washer, and 1 quick release billet aluminum mount with quick release pin.
