Overview
The Fox Racing Shox 2.0 Performance Series IFP Shock, part number 980-24-647, is a 2.0 in body direct replacement shock with an internal reservoir for 4WD rear applications. IFP stands for internal floating piston, the separator that keeps shock oil apart from the gas charge.
Fox says each application is engineered and tested by its own engineers to maximize travel and performance on and off the road. This model uses OEM direct replacement mounting, so it is designed to replace the factory shock rather than to be installed with separate brackets.
Key features
- Internal reservoir design
- OEM direct replacement mounting
- 2.0 in body diameter
- 5/8 in shaft diameter
- Black and aluminum finish
- Hydraulic, gas charged operation
- It is designed for 4WD rear applications.
Choosing a replacement shock
A replacement shock controls how the axle and body move together, so matching the original unit matters more than any single feature. Start by measuring the old shock’s eye-to-eye length, its compressed and extended dimensions and the mounting hole spacing at both ends. Those figures decide whether a new shock will sit where the old one did without binding or bottoming out on the bump stops. An internal reservoir keeps the oil and gas separated inside a single body, which helps with heat during long descents but does not change how the shock is mounted.
Replacement shocks are often swapped in pairs on the same axle so that damping feels even side to side. If the rest of the suspension is worn, such as bushings, bump stops or upper mounts, new shocks may not perform as expected, so inspect those parts at the same time. Keep the old shock to compare hardware and bushing sizes, and check that the mounting bolts are tightened to the vehicle’s service values after the first few drives.
Specifications
| Brand | Fox Racing Shox |
|---|---|
| Part number | 980-24-647 |
| UPC | 70000561728 |
| Body diameter | 2.0 in |
| Shaft diameter | 5/8 in |
| Finish | Black and aluminum |
| Reservoir | Internal |
| Mounting | OEM direct replacement |
| Travel, extended and collapsed length | Application specific |
| Operation | Hydraulic, gas charged |
| Application | 4WD rear |
Vehicle fitment
It is intended for 4WD rear applications. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that the original shock’s mounting points match the OEM direct replacement mounting before removing it. Support the vehicle on stands while the shock is removed and installed.
What’s included
Check the package contents against your installation before starting.
Not included: This shock is sold separately, so any additional shocks must be ordered separately.









