Overview
The Bushwacker Ford Cut Out Front and Rear Fender Flares, part number 20940-02, are a set of four Cut-Out flares with 3 inches of width/coverage for off-road Ford trucks. Model years, trims and chassis codes are not known for this set, so fit is not confirmed until the year and model are checked.
Cut-Out flares remove sheet metal from the body so the wheels can articulate further and the tires have more room. The custom approach gives a smoother appearance and greater strength, and it is fastened with rivets. The flares are molded from Dura-Flex 2000, which is UV protected, and they have an OEM matte black finish that can be painted.
Cut-Out flares are individually made for a specific Ford, so the year and model must match before any cutting begins.
Key features
- Sheet metal removal maximizes wheel articulation
- Set of four flares covering front and rear positions
- 3 inches of width/coverage
- Rivet installation for a secure fit
- 100% UV protected Dura-Flex 2000 with no chalking
- OEM matte black finish that is easy to paint
- Made in the USA with a Limited Lifetime Warranty
Before you cut body panels
Cut-out flares change the body, so planning matters more than with bolt-on flares. Mark the cut lines carefully, check clearance with the tires turned fully to both sides, and confirm the wheels and suspension have the travel you expect before any metal is removed. Sheet metal that is removed cannot be restored to the factory panel.
After cutting, the exposed edges need protection against rust, and the rivets should be checked for tightness after the first few drives. Plan for the extra weight of the flares when considering suspension or tire changes. A professional fitter can help with straight cuts and even spacing.
- Turn the wheels fully to check tire clearance before cutting
- Seal bare sheet metal edges against rust
- Check rivets after the first few drives
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 20940-02 |
| UPC | 90689120151 |
| Quantity | Set of 4 |
| Position | Front and rear |
| Width/coverage | 3 in |
| Material | Dura-Flex 2000 |
| Finish | OEM matte black, paintable |
| Mounting | Tough rivet installation, with sheet metal cut |
| Warranty | Limited Lifetime |
Vehicle fitment
Model years, trims and chassis codes are not known for this set. Confirm fit for your vehicle’s year, model and trim before cutting or installing.
Cut-Out flares are sized for particular vehicles, so the year and model must match. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Cut-Out flares require cutting body sheet metal, which is a permanent change. Read the full steps for your specific model before marking any panel.
What’s included
A set of four Cut-Out fender flares, front and rear, with the rivet installation described by Bushwacker.














