Overview
The Fabtech FTT94001BK is a pair of rear body corner guards for Jeep tub corners, made from 3/16-inch thick steel. Fabtech describes them as protection for the rear corners, and they can also cover existing body damage.
Each set is powder coated in a semi-gloss black finish and has openings for the factory OE tail lights and gas filler. Mounting requires drilling, and flush countersunk hardware is supplied for the job.
Key features
- 3/16-inch thick steel construction
- Semi-gloss black powder coat finish
- Openings for factory OE tail lights and gas filler
- Flush countersunk hardware included
- Sold as a set (pair)
- Direct fit, with cutting or drilling required
Preparing for drilling
Steel corner guards are heavy and rigid, so the mounting work is mostly about accuracy. Set the guard in position, then mark each hole with a center punch before drilling. Starting with a smaller pilot hole helps keep the bit from wandering on steel, and the larger hole can be opened afterward.
Check the tail light and gas filler openings against the body before committing to any hole. Steel drilled through without checking can leave a guard sitting off line, and that is hard to correct once the bolts are in. Dry fit the guard first, and only drill when the gaps around the openings look even.
After drilling, remove burrs from each hole and clean any bare steel. Touch up the edges with a suitable primer and black paint so rust does not start where the metal was cut.
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTT94001BK |
| UPC | 674866017887 |
| Material | Steel, 3/16-inch thick |
| Finish | Black powder coat, semi-gloss |
| Corner type | Short |
| Installation type | Cutting or drilling required |
| Quantity | Set (pair) |
Vehicle fitment
These guards are a direct fit for Jeep tub rear corners. Confirm fit for your vehicle’s year, model and trim before you buy.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Drilling is part of the install, so mark the hole positions and check them against the tail light and gas filler openings before drilling. Wear eye protection when drilling steel.
What’s included
One set (pair) of body corner guards with flush countersunk hardware.









