Overview
The Fabtech FTS50 is a 3/4-16 right hand jam nut for specialty fabrication work. It is intended for right hand threaded Teflon heim ends sold as single units, so it suits builds that need a 3/4 inch right hand jam nut on a heim end. It is a universal fit part.
Key features
- Right hand thread in 3/4 inch -16 size
- Intended for right hand threaded Teflon heim ends
- Suited to specialty fabrication work
- Universal fit, not tied to one vehicle
Choosing a jam nut
A jam nut locks a threaded heim end or rod end at a set length. Once the joint is adjusted to the right position, the nut is tightened against the body so the setting does not drift under load. On a heim end, the jam nut and the threads must match exactly, because a mismatched thread can strip or fail to hold the adjustment. Right hand threads are the common choice for many steering and suspension joints, but the joint itself determines the direction, so check it before buying.
Look at the thread pitch, diameter and the material of the nut when choosing a replacement. Steel jam nuts are typical for heavy use, and the nut should seat squarely against the housing without cross threading. After installation, check that the joint still moves freely and that the nut is fully tight. Recheck the setting after the first few trail runs, since vibration can loosen a jam nut that was tightened correctly at the bench.
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS50 |
| UPC | 674866011533 |
| Thread size | 3/4 inch – 16 |
| Thread direction | Right hand |
| Fitment | Universal fit |
Vehicle fitment
No vehicle is named for this part. Fitment depends on the heim end or rod end thread matching the 3/4-16 right hand size.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package contains the FTS50 jam nut.







