Overview
The Currie JK-9704TR-1 is a driver side replacement tie rod end for the Currectlync tie rod, for 2007–2018 Jeep Wrangler (JK) models. It replaces the end on a Currectlync tie rod and will not fit a stock tie rod.
The end is greasable and comes with a boot, nut, cotter pin and zerk fitting. It is a direct fit for the JK application.
Key features
- Driver side replacement end for the Currectlync tie rod
- Greasable joint with zerk fitting included
- Boot, nut and cotter pin included
- Fits the Currectlync tie rod only; will not fit a stock tie rod
- Listed direct fit for 2007–2018 Wrangler JK
Greasing and inspecting the joint
A greasable tie rod end relies on regular lubrication to keep the ball joint working smoothly and to push out water and dirt. Grease after installation, then continue on the schedule set by the vehicle’s maintenance plan. Grease that comes out around the boot shows the seal is doing its job, while dry or gritty grease suggests the joint has been working hard.
Inspect the boot each time the wheels come off. A torn boot lets grit into the joint and speeds up wear, and the end should be replaced rather than patched. Check for play by rocking the wheel with the vehicle safely supported. Keeping the steering linkage clean makes these checks easier, and an alignment reset after any replacement keeps the tires wearing evenly.
Specifications
| Brand | Currie |
|---|---|
| Part number | JK-9704TR-1 |
| UPC | 817783006620 |
| Position | Driver side |
| Compatibility | Replacement end for Currectlync tie rod only |
| Lubrication | Greasable |
| Included | Boot, nut, cotter pin, zerk fitting |
| Fitment type | Direct Fit |
Vehicle fitment
Listed Wrangler JK entries run from 2007 through 2018, with Unlimited trims included alongside Rubicon, Sahara, Sport, Sport S, X and the anniversary editions.
This end works only with a Currectlync tie rod, so a stock Wrangler tie rod is not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lubricate the zerk fitting after fitting, and have the front alignment checked afterward.
What’s included
The boot, nut, cotter pin and zerk fitting come with the driver side tie rod end.









