Overview
The Crown Automotive 52088431 is a front axle end track bar bushing for Jeep Wrangler models. It fits the 2004–2006 Jeep Wrangler (LJ), including the Unlimited and Unlimited Rubicon, and the 1997–2006 Jeep Wrangler (TJ), including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X models.
Front track bar wear
The track bar holds the front axle centered side to side, so the bushings at its ends see steady load on every drive. Worn bushings allow the axle to shift, which can cause wander, a loose feel on the highway and uneven tire wear. Because the axle end is involved, replacing the bushing is a good time to check the track bar itself for bent or cracked parts.
Front and rear track bar bushings wear differently, so only the front axle end bushing is covered by this part. After replacement, have the front alignment checked, since changes at the axle end affect toe. Follow the installer’s lubrication guidance for contact surfaces, and inspect the bushing again after rough off-road use.
- Check track bar ends for play
- Inspect the frame mount for cracks
- Verify toe after the bushing is replaced
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52088431 |
| UPC | 848399015959 |
| Position | Front |
| Location | Front axle end |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ) and the 1997–2006 Jeep Wrangler (TJ), including the trims covered above.
Rear track bar bushings and other Wrangler generations are not covered by this fitment. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the bushing is at the front axle end, the track bar should be checked for wear at the same time. Alignment should be checked after the bushing is replaced.
What’s included
The package is a single front axle end bushing. Check whether any hardware is needed for your installation before starting.








