Overview
The Crown Automotive J0915664 is a steering seal kit for the pitman arm shaft, sold as one kit per side. It is made for front Dana 25, Dana 27 and Dana 30 Standard axles.
The kit is axle-based. No vehicle, year or model is named, so check the axle type on your Jeep before buying.
Key features
- One kit per side
- Front axle application
- Dana 25, Dana 27 and Dana 30 Standard axles
- Direct fit design
Keeping steering seals dry
A steering seal on a pitman arm shaft keeps lubricant in the steering gear and keeps dirt and water out. Leaks usually appear as wet residue on the inside of the wheel or on the steering gear housing. Because these seals work in a dusty, wet area of the front axle, they are exposed to more wear than many other seals on the vehicle.
When a seal is replaced, check the shaft surface for scoring or pitting, since a rough shaft can damage a new seal quickly. Confirm the steering gear fluid level after service, and inspect the seal again after the first few drives. Replacing a seal alone may not solve a leak if the gear housing is also worn.
- Look for wet residue on the steering gear housing
- Check the pitman shaft surface before installing a new seal
- Confirm the fluid level after service
- Recheck for leaks after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0915664 |
| UPC | 848399079159 |
| Axle location | Front |
| Axle types | Dana 25, Dana 27, Dana 30 Standard |
| Quantity | 1 kit per side |
Vehicle fitment
Fitment is listed by axle type only: front Dana 25, Dana 27 and Dana 30 Standard. No vehicle year or model is given.
Confirm fit for your axle type and your vehicle’s year, model and trim before ordering.
















