Overview
The Crown Automotive 4470365 is a steering gear seal kit for the pitman shaft on the 1997–2001 Jeep Cherokee (XJ), the 1997–1998 Grand Cherokee (ZJ) and the 1997–2002 Wrangler (TJ).
It is a pitman arm shaft seal kit that goes at the pitman shaft. The pitman shaft is the output shaft of the steering gear, so the seal keeps steering fluid inside the gear where the shaft exits. It is a direct fit.
Crown Automotive describes itself as a manufacturer and distributor of replacement parts for Jeep vehicles, with over 8,000 part numbers, including many factory-discontinued items, and says its quality is matched by an exceptional warranty.
The manufacturer fitment list names specific trims: Classic, Country, Limited, SE and Sport for the XJ, 5.9 Limited, Laredo, Limited, Orvis and TSi for the ZJ, and SE, Sahara, Sport and X for the TJ. The kit does not change steering geometry and has nothing to do with lift height.
Key features
- Steering gear seal kit for the pitman shaft
- Categorized as a pitman arm shaft seal
- Direct fit
- Fits the Cherokee (XJ), Grand Cherokee (ZJ) and Wrangler (TJ)
- Replacement part from a Jeep-focused manufacturer
- Does not alter steering geometry
Recognizing a pitman shaft leak
The pitman shaft exits the steering gear housing, and the seal at that point keeps the gear’s internal fluid in place. A leak often shows as dark, wet fluid collecting around the base of the pitman arm or on the outside of the gear housing. Over time the leaking fluid can drop the level in the gear, which may lead to stiffer steering or noise during turns.
Before replacing a seal, clean the area thoroughly and run the steering through its full travel to confirm where the fluid is coming from. Leaks can also come from the pitman arm nut, the housing cover, or hose fittings, so a clean inspection helps avoid replacing the wrong part. Check the fluid level once the job is complete and watch for seepage on the next few drives.
- Wet fluid around the base of the pitman arm
- Lower fluid level in the steering gear
- Stiffer steering or noise through turns
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4470365 |
| UPC | 848399004144 |
| Product type | Steering gear seal kit |
| Category | Pitman arm shaft seal |
| Location | At the pitman shaft |
| Fit type | Direct fit |
Vehicle fitment
It fits three Jeep models between 1997 and 2002, with the trims shown below.
- 1997–2001 Jeep Cherokee (XJ) (Classic, Country, Limited, SE, Sport)
- 1997–1998 Jeep Grand Cherokee (ZJ) (5.9 Limited, Laredo, Limited, Orvis, TSi)
- 1997–2002 Jeep Wrangler (TJ) (SE, Sahara, Sport, X)
The XJ is covered through 2001, the ZJ for 1997–1998 only and the TJ through 2002. Other model years are not covered. Make sure your trim is one of the ones named before ordering.
Installation notes
Because the seal sits on the steering gear, have a qualified technician do the work and check for leaks afterward.
What’s included
Check the package contents against your installation before starting.
