Overview
The Crown Automotive 6036424AA is a front hub to rotor stud, part number 6036424AA, in the wheel stud category. It replaces the stud that holds the hub and rotor together on the front side.
It is sold as universal fit, which does not confirm a match to any particular front hub. Dimensions, thread and material should be checked against the hub and rotor you are replacing.
Key features
- Front hub to rotor stud
- Part number 6036424AA
- Marked universal fit
- Carries UPC 848399047196
Working on the front hub
The front hub to rotor stud is the fastener that locks the rotor to the hub flange, so it carries braking torque as well as the clamp load from the nut. A stud that has been overtightened or left to rust can stretch, gall or snap at the shoulder. Look for thread damage, a loose fit in the flange, or fine cracks near the head before deciding whether to replace it.
Front hubs on many vehicles are serviced with the rotor off, which gives access to the stud from behind. Work on one stud at a time so the rotor stays aligned, and keep the mating faces clean. Replacing a stud is a good time to inspect the bearing seal and the rotor face for heat cracks or uneven wear.
- Check the hub bore for wear
- Clean the rotor mating face
- Inspect the stud for bent or galled threads
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 6036424AA |
| UPC | 848399047196 |
| Part type | Front hub to rotor stud |
Vehicle fitment
Confirm fit for your front axle, vehicle and year before ordering. Match the stud against the hub and rotor you are replacing before installing it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Follow a service manual for your vehicle’s removal and fitting steps before starting. Removing a front hub to rotor stud usually means taking the rotor and hub apart.
What’s included
Check the package contents against your installation before starting. Confirm whether a quantity, nut or washer is needed.









