Overview
The Crown Automotive Front Fender Flare Hardware Kit, part number 5AGFRKIT, is a front fender flare hardware kit for the 1984–1994 Jeep Cherokee XJ.
The kit includes 2 U-clip nuts, 14 push-in fasteners, 18 nuts and 12 screws. Compare the kit with the hardware you are replacing before installing, since flare and bracket sizes need to match your fenders.
Key features
- Two U-clip nuts, 14 push-in fasteners, 18 nuts and 12 screws
- Designed for the front fenders
Fender flare fastener care
Fender flares are held on by a mix of clips, push-in fasteners and bolts, and the fasteners are often the weak point. Push-in fasteners can work loose after rough trail use, and U-clip nuts can strip if they are overtightened. Inspect the fasteners at the start of each season and after hard off-road runs.
Plastic push-in fasteners should be replaced when their heads break or the pins no longer grip. Avoid forcing a damaged fastener back into its hole, since it may crack the fender lip. Keep spare clips on hand, as they are inexpensive and easy to lose during removal.
Flare panels move with the fenders, so check the gap between flare and tire after the install. Adjust mounting points gently and retighten fasteners once the flare has settled. If the fender is bent near a mount, straighten it before fitting the flare, because the new clips will not hold on a deformed edge.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5AGFRKIT |
| UPC | 848399077735 |
| Front or rear | Front |
| Contents | 2 U-clip nuts, 14 push-in fasteners, 18 nuts, 12 screws |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the front of the 1984 to 1994 Jeep Cherokee XJ.
The fit list runs through 1994, so it does not include the 1995 or 1996 XJ. Confirm your vehicle’s year, model and trim before ordering.
What’s included
2 U-clip nuts, 14 push-in fasteners, 18 nuts and 12 screws.









