Overview
The Crown Automotive 943131A is a drum brake adjuster screw assembly for the driver side, front or rear, on 11 inch brakes. It fits the 1974–1978 Jeep CJ5, 1974–1975 CJ6 and 1976–1978 CJ7.
The adjuster screw assembly lets the drum brake shoes be set closer to the drum as lining wears. This part number is the driver-side version.
Key features
- Adjuster screw assembly for drum brakes
- Driver side, front or rear
- Made for 11 inch brakes
- Direct-fit replacement design
Adjuster maintenance
A drum brake adjuster screw sets the gap between the shoes and the drum as the linings wear. When the gap grows, the pedal can feel low or the brakes can pull, so the adjuster matters for both stopping and braking balance. Check it whenever you reline the shoes or replace the drum, and make sure the screw turns freely without binding or stripping.
Drum brake systems are usually serviced in pairs or as a full set, so look at the matching parts on the same axle before ordering. Clean the threads and apply a light coat of suitable grease where the screw contacts the shoes. Inspect the backing plate, springs and hardware for wear, and recheck the adjustment after the first few stops on a new installation.
- Check the screw turns freely
- Inspect springs and hold-down hardware
- Re-adjust after new linings are fitted
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 943131A |
| UPC | 848399049961 |
| Part type | Drum brake adjuster screw assembly |
| Brake size | 11 inch |
| Side | Driver |
| Position | Front or rear |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1974–1978 Jeep CJ5, the 1974–1975 CJ6 and the 1976–1978 CJ7.
It fits only the listed years of CJ5 and CJ7 models. Confirm fit for your vehicle’s year, model and trim before ordering, since Cherokee and Wrangler models are not covered.
What’s included
- One driver-side drum brake adjuster screw assembly









