Overview
The Crown Automotive drive shaft bolt, part number 6036415AA, is a front drive shaft to transfer case bolt for Jeep vehicles.
It is a direct fit for Jeep vehicles, so the bolt should be compared with the one you are replacing before installation.
Key features
- Used on the front drive shaft to transfer case connection
- Direct fit for Jeep vehicles
- Jeep replacement part
- Crown Automotive part number 6036415AA
Before you install
Front driveshaft bolts carry torque between the driveshaft and the transfer case output, so they are loaded every time the vehicle moves under power or on the brakes. Over time a fastener can loosen, its threads can stretch, or corrosion can build up where the flange meets the transfer case. Before fitting a new bolt, clean the mating surfaces and check that the threads run freely by hand so the joint can be tightened squarely.
When the driveshaft comes off for work on the transfer case or front axle, it is a good time to look at the other hardware in the joint. Replace any bolt with rounded heads, damaged threads or signs of stretching. A vibration that changes with road speed can point to a loose connection, so inspect the fasteners again after the driveline has been disturbed.
- Check thread condition before reusing an old bolt
- Inspect the flange face for wear or scoring
- Replace damaged hardware rather than reusing it
- Recheck fasteners after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 6036415AA |
| UPC | 849603020516 |
| Location | Front drive shaft to transfer case |
| Fitment label | Direct fit |
Vehicle fitment
Labeled as direct fit for Jeep vehicles, with no year, make or model given.
Make sure your vehicle’s year, model and trim match the bolt, and match the bolt to your front driveshaft and transfer case before installing it.
What’s included
Count the bolts your front driveshaft to transfer case connection needs before ordering.
