Overview
The Crown Automotive 83506250 is an AX15 1st and 2nd synchronizer plate for manual transmissions. Quantity three is required for the job.
It fits the 1989–1999 Jeep Cherokee (XJ), the 1993 Jeep Grand Cherokee (ZJ), the 1997 Jeep Wrangler (TJ) and the 1988–1995 Jeep Wrangler (YJ).
Key features
- AX15 1st and 2nd gear synchronizer plate
- Three are needed for each job.
- Part number 83506250 with UPC 848399026795
- It is a direct fit across the XJ, ZJ, TJ and YJ models.
AX15 1st and 2nd gear wear
The 1st and 2nd synchronizer plate works with the hub and sleeve on the lower gears, which take the most use in stop-and-go driving and in low-speed off-road work. Wear usually appears as hard shifts into first, a gear that clashes on the way in, or a faint grind when the transmission is cold.
Plates for the AX15 are often replaced with the synchro rings and hub, since the parts wear against the same surfaces. Before reassembly, check that the plates sit flat and that the sleeve moves freely over the hub. A technician familiar with AX15 units can judge whether the rest of the gearbox needs work at the same time.
- Check plate faces for scoring
- Confirm the sleeve moves freely
- Replace worn rings alongside the plates
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83506250 |
| UPC | 848399026795 |
| Transmission | AX15 manual |
| Position | 1st and 2nd gear |
| Quantity required | Three |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1989–1999 Jeep Cherokee (XJ) with Base, Briarwood, Classic, Country, Laredo, Limited, Pioneer, SE and Sport trims; the 1993 Jeep Grand Cherokee (ZJ) in Base and Laredo trims; the 1997 Jeep Wrangler (TJ) Sport; and the 1988–1995 Jeep Wrangler (YJ).
Grand Cherokee years other than 1993, Wrangler TJ years other than 1997, and Wrangler JK models are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Synchronizer plates sit inside the gearbox, so a technician with AX15 experience should handle replacement.
What’s included
Synchronizer plates for the 1st and 2nd gear position, with quantity three required.









