Overview
The Bushwacker Chevrolet S-10 Blazer Cut-Out Fender Flares, model number 41009-11, are a front pair in OE matte black with screw pockets. The flares are paintable and listed with 3 inches of tire coverage.
Cut-Out Fender Flares are designed for extreme off-road use. Each set is designed for the Chevrolet or GMC it is made for, to maximize off-road wheel travel and keep tire coverage. The custom design aims for a smoother appearance and added strength.
Cut-out flares require cutting the body sheet metal to reach maximum articulation and coverage for oversized tires. The design uses rivet installation, so plan for the cutting and rivets before mounting the pair.
Key features
- Front position, pair
- OE matte black finish, paintable
- Screw pocket design
- 3 inches of tire coverage
- Designed to maximize off-road wheel travel
- Cut-out design requires cutting the body sheet metal
Cutting and rivets before mounting
Cut-out flares change the body, so the decision is different from a bolt-on set. Cutting the sheet metal opens the fender to allow more wheel travel and tire coverage, and the cut edges need protection from rust after the work is finished. Plan the layout with the flare held in place, and mark the cuts before drilling or cutting.
Rivets and screw pockets hold the flare to the body, so check the fasteners after the first few drives and again after off-road runs. Before cutting, confirm the area behind the fender is clear of wiring, brake lines and fuel lines. Paint the cut edges with primer and a matching topcoat, and keep the OE matte black finish clean with mild soap and water.
Specifications
| Brand | Bushwacker |
|---|---|
| Model number | 41009-11 (Cut-Out Fender Flares) |
| UPC | 90689103383 |
| Style | Cut-out, screw pocket |
| Finish | OE matte black; paintable |
| Quantity | Pair |
| Position | Front |
| Tire coverage | 3 inches |
Vehicle fitment
The pair is for the Chevrolet S-10 Blazer.
Confirm fit for your S-10 Blazer’s year, model and trim before ordering.
Installation notes
Cut-out flares require cutting body sheet metal, and the design uses rivet installation. Plan the cutting and rivets before mounting the pair.
What’s included
A pair of front cut-out fender flares with screw pockets.









