Overview
The Bushwacker Ford OE Style Fender Flare Set in Ingot Silver, part number 20937-52, provides four pre-finished flares for the front and rear of the 2016-2017 Ford F-150. Each flare adds up to 0.50 inches of tire coverage, and the Ingot Silver finish is applied before the flares are installed.
The flares are designed to match the paint on a new truck, so Ingot Silver owners get the color without a separate paint step. Each set is made in the USA from warp-resistant Dura-Flex 2000 that Bushwacker says is 100% UV protected.
The OE Style design adds more tire coverage and clearance for trucks and SUVs, while helping protect the vehicle from dirt and debris. The stainless steel hardware and edge trim come installed, so mounting needs no drilling.
Each flare arrives pre-finished, so the Ingot Silver color is already applied and no separate paint step is described.
The list covers the 2016-2017 F-150 in six trims, so check your trim against that list before fitting.
Key features
- Pre-finished Ingot Silver, color-matched to the truck
- Up to 0.50 inches of tire coverage
- Edge trim and stainless steel hardware pre-installed
- No drilling required for installation
- 100% UV protected, warp-resistant Dura-Flex 2000
Keeping pre-finished flares looking good
Pre-finished flares carry a color that was applied before they were installed, so the most important care is protecting that finish. Rinse off road grit with a gentle spray and wash with mild soap rather than abrasive cleaners. Check the flare edges after rough drives, since stones can chip the surface and leave a spot where moisture can reach the plastic. A small chip can be touched up with matching paint before it spreads.
Keep the mounting hardware tight, because a loose flare can rub against the tire and wear the finish along its edge. Installation is fast when the edge trim and hardware are already in place, but it is worth rechecking the fit after the first week of driving.
- Rinse grit with a gentle spray
- Wash with mild soap only
- Touch up chips before they spread
- Recheck fit after the first week
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 20937-52 |
| UPC | 700008511471 |
| Quantity | Set of 4 |
| Position | Front and rear |
| Width/coverage | 0.50 in |
| Color | Ingot Silver, pre-finished |
| Material | Dura-Flex 2000 |
Vehicle fitment
It is designed for the 2016-2017 Ford F-150 in the King Ranch, Lariat, Limited, Platinum, SSV, XL and XLT trims.
The list is limited to the 2016-2017 F-150, so other years and the Super Duty are not covered by it. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Bushwacker describes mounting as drill-free, since the edge trim and stainless steel hardware are already in place on these flares.
What’s included
A set of four OE Style fender flares in Ingot Silver, with the edge trim and stainless steel hardware pre-installed.










