Overview
The Bushwacker 40087-02 is a pair of pocket style front fender flares for the Chevrolet Silverado. The flares add 2 inches of width and tire coverage at the front and are designed to complement oversized tires and high-clearance lift kits. Bushwacker says they are custom-designed for the Silverado, but no model years are given for this part number.
The pocket style design holds each flare against the body with recessed stainless steel bolts, and no drilling is needed. The Dura-Flex 2000 surface is made in the USA, UV protected and resistant to chalking. The OEM-style matte black finish can be left as-is or painted to match or accent the body color.
Key features
- Pocket style design for the front position
- 2 inches of width and tire coverage
- Recessed stainless steel bolts for a bolt-on look
- No drilling required for installation
- 100 percent UV protected Dura-Flex 2000
- OEM-style matte black finish that is easy to paint
Front pocket flare fit notes
Pocket style fronts sit against the fender with recessed hardware, so the flare position depends on how accurately the mounting points line up. Set the pair by eye first, then measure the gap at the top and bottom of each flare. A gap that is even on both sides usually means the fit is right.
Front tires can touch a flare during hard turns or when the suspension loads up over bumps. A test drive over rough ground is a good way to find early rub marks. If rub appears, adjust the tire size or the flare position before the paint or edges wear through.
Heavier trucks and lifted trucks tend to load the front end more, which puts extra stress on the mounting points. Check the bolt torque after the first week, and keep the flare clean so grit cannot work under the edge.
- Measure gap at top and bottom of each flare
- Test-drive over rough ground
- Re-check bolts after the first week
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 40087-02 |
| UPC | 90689110961 |
| Position | Front |
| Width and tire coverage | 2 inches |
| Quantity | Sold as a pair |
| Fit type | Direct fit |
| Material | Dura-Flex 2000 |
| Finish | OEM matte black, paintable |
Vehicle fitment
The front pair is designed for the Chevrolet Silverado to complement oversized tires and high-clearance lift kits. Silverado model years are not set for this part number, so match your year, model and trim to the vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The install needs no drilling, since the pocket style flares are bolted on with recessed stainless steel hardware.
What’s included
One pair of pocket style front fender flares. The rear pair is part 40092-02 or 40094-02, and the full set is part 40942-02 or 40924-02.
Not included: the rear pair and the full set are listed under separate part numbers.









