Overview
The Borla Pro XS muffler, part number 40358, is a straight-through stainless steel muffler with 2.5-inch inlet and outlet tubes. Its inlet sits offset while the outlet is centered, which matters when lining up the muffler with your existing pipe.
It is a universal fit with no vehicle named, so the tube size and inlet position are what to match before fitting.
Key features
- Straight-through muffler design
- Stainless steel construction
- 2.5-inch inlet and 2.5-inch outlet
- Offset inlet with centered outlet
Setting up an offset inlet
An offset inlet changes how the muffler lines up with the pipe coming from the engine, so the fit is more about geometry than tube size alone. Mock up the pipe and muffler before welding, and mark the spot where the clamp or weld will sit. Small adjustments to the bend in the pipe are often easier than forcing a rigid joint.
Straight-through mufflers usually have less internal restriction, which many drivers notice as a louder exhaust note. Balance that with local sound limits and passenger comfort on longer drives. Before finishing the install, check that the tailpipe clears the bumper, the rear axle and any heat-sensitive parts. Reinstall any heat shields removed during the swap.
- Mock up the pipe before welding
- Mark the clamp position before tightening
- Check tailpipe clearance
Specifications
| Brand | Borla |
|---|---|
| Part number | 40358 (BOR40358) |
| Material | Stainless steel |
| Muffler type | Straight through |
| Inlet location | Offset |
| Outlet location | Centered |
| Tube size (inlet/outlet) | 2.5 in / 2.5 in |
| Fitment | Universal Fit |
Vehicle fitment
The muffler is marked Universal Fit, and no vehicle, model year or engine is named for it. Plan the fitment around the offset inlet and 2.5-inch tubes.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the inlet is offset, orient the muffler before clamping or welding so the pipe lines up without strain.
What’s included
Check whether hangers, clamps or tailpipe sections are needed for your install.









