Overview
The BedRug Premium Front Floor Liner, part number BEDBRTJ97F, is a three-piece charcoal liner for the front footwells of Jeep Wrangler TJ and LJ vehicles. It fits the 1997–2006 Jeep Wrangler (TJ) and the 2004–2006 Jeep Wrangler (LJ), including Unlimited versions.
The surface is 100% polypropylene fiber made to look and feel like carpet. The material is tough and resists impact dings, and the fibers are waterproof and resist UV exposure and fading. These pieces install and remove without taking out the seats or center console and without grinding off factory paint, which takes less time than a spray-in liner.
Key features
- Carpet-look 100% polypropylene surface that is waterproof and resistant to UV exposure and fading
- Foam backing similar to life-jacket foam, which does not absorb water and will not mold or mildew
- Three pieces: driver footwell, passenger footwell and rear seat footwell, plus heat shields
- Installs without removing the seat brackets or the center console
- No removal or grinding of factory paint is needed, unlike spray-in liners
- Backed by a 3-year warranty
Choosing a footwell liner
Footwell liners sit where mud, water and dropped gear collect at the front of the cabin, so the surface should be easy to clean. A carpet-look liner gives a finished appearance while keeping debris on top rather than in the carpet below. Because the pieces are removable, they can be taken out for a dry floor or a thorough scrub, which is useful after trips through wet or sandy terrain.
Fit depends on the vehicle generation, so confirm the year and model before buying. Liners built for an older floor can sit higher or lower than a newer one, leaving gaps where debris can slip underneath. Heat shields help separate the footwell from warm components beneath the floor.
- Check the seating around the seat brackets
- Clean the surface with mild soap after salt or sand exposure
- Look for lifted corners near the center console
Specifications
| Brand | BedRug |
|---|---|
| Part number | BEDBRTJ97F |
| Position | Front |
| Color | Charcoal |
| Pieces | 3: driver footwell, passenger footwell, rear seat footwell, plus heat shields |
| Material | 100% polypropylene carpet-like fibers |
| Backing | Foam similar to that used in life jackets |
| Warranty | 3-year |
| Made in | U.S.A. |
Vehicle fitment
It fits the 1997–2006 Jeep Wrangler (TJ), including 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X versions, and the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon versions.
Its fit is limited to the TJ and LJ years above. For the 2007 and later Wrangler JK or JL, the Gladiator, or the earlier YJ and CJ models, confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
No removal of the seats or the center console is needed for these pieces, unlike with spray-in liners.
What’s included
Three pieces: the driver footwell piece, the passenger footwell piece and the rear seat footwell piece, plus heat shields.













