Overview
The BedRug BedTred cargo kit in charcoal, part BTJK07R2, is the rear custom-molded floor piece for the two-door Jeep Wrangler JK from 2007 through 2010. It fits the Rubicon, Sahara, Sport and X trims with two doors.
The BedTred surface is 100% waterproof, does not absorb water and dries quickly. It resists harsh chemicals and will not stain, hold odor or grow mold or mildew. A 1/4-inch thick, 100% polypropylene foam layer insulates the cargo area from road noise and heat.
Key features
- Rear piece custom-molded for the two-door JK
- 100% waterproof BedTred surface that does not absorb water
- Resists harsh chemicals; will not stain or grow mold or mildew
- 1/4-inch thick polypropylene foam insulation
- Removable sections that can be hosed off after trail use
Keeping the cargo floor clean
A molded cargo floor earns its keep on muddy days and after camping trips. Dirt and sand collect in the low spots of a carpeted floor, but a one-piece surface with raised edges can be rinsed without soaking the padding underneath. Lift out the removable sections, knock loose debris onto the trail, and hose them off before drying.
Some owners pair a cargo floor with a cargo divider, a bag system or a tie-down set. Choose accessories that bolt to the tie-down points or the seat belt anchors rather than sliding across the surface, since sliding parts can scuff the finish over time. Check that bags have padded or rubber feet if they will sit directly on the floor.
Foam-backed floor pieces can trap moisture if left wet for long periods. Air the vehicle out after washing and check the underside of removable sections for grit. Periodic inspection helps keep the floor fitting snugly against the body.
- Rinse the surface after salt or mud exposure
- Dry the floor before reinstalling sections
- Inspect tie-down hardware for wear
Specifications
| Brand | BedRug |
|---|---|
| Part number | BTJK07R2 |
| Position | Rear |
| Color | Charcoal |
| Surface | BedTred, 100% waterproof |
| Foam | 1/4-inch thick, 100% polypropylene |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2007–2010 two-door Jeep Wrangler JK models: Rubicon, Sahara, Sport and X.
Four-door Wrangler Unlimited models, 2011 and later JK models and the Wrangler JL are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation does not require removing the seats or the center console. Extra mats or liners are not recommended on top of this kit, because their backing nibs slide on the BedTred surface instead of gripping it.
What’s included
The charcoal rear cargo kit for part BTJK07R2. Not included: the front kit, which is a separate piece.















