Overview
The BedRug front floor kit in charcoal, part BTJK11F2, is a custom-molded, die-cut floor piece for the front of the two-door Jeep Wrangler JK. It fits 2011–2018 two-door JK models, including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport and Sport S trims.
The front kit is one half of BedRug’s front and rear setup and gives a rugged spray-in look without the spray-in process. Its BedTred surface is 100% waterproof, does not absorb water and resists harsh chemicals, so the pieces can be lifted out and hosed off after a long day outdoors. A 1/4-inch thick polypropylene foam layer underneath insulates the cabin from road noise and heat.
Key features
- Die-cut to the front floor of the two-door Wrangler JK
- BedTred surface: 100% waterproof and non-absorbent
- Resists harsh chemicals and dries quickly
- 1/4-inch thick, 100% polypropylene foam insulation
- Removable pieces that clean up with a hose
- Installs without grinding or removing factory paint
Front floor care after trail use
A molded front floor liner catches mud, sand and water that would otherwise sit on carpet or bare metal. Because the surface is nonabsorbent, most grit can be rinsed away rather than scrubbed, which keeps the surface in good shape. Pull the removable pieces out for cleaning when the cabin gets wet, and check underneath for moisture before setting them back in place.
Grit that gets under the edges can work against the factory floor, so sweep the corners before refitting. Dry the pieces fully before reinstalling, since trapped water can encourage odor on the underside. Inspect the liner edges after hard use and press any lifted corner back into position. Keep heavy gear off the front floor when it is not needed so the liner stays flat.
- Rinse grit off with a hose before lifting pieces
- Sweep corners before refitting
- Let pieces dry fully before reinstalling
- Check edges for lifting after hard use
Specifications
| Brand | BedRug |
|---|---|
| Part number | BTJK11F2 |
| Position | Front |
| Color | Charcoal |
| Surface | BedTred, 100% waterproof |
| Foam | 1/4-inch thick, 100% polypropylene |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2011–2018 two-door Jeep Wrangler JK models in the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport and Sport S trims.
Four-door Wrangler Unlimited JK models, the 2007–2010 JK years and the Wrangler JL are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The seat brackets and center console stay in place during installation, so the front kit does not require their removal.
What’s included
The charcoal front floor kit for part BTJK11F2. Not included: the rear kit, which is a separate item.











