Overview
The Addictive Desert Designs Stealth Fighter winch front bumper, part ADSF221203030103, is a black steel front bumper for the 2019 Ford Ranger. The radius plate design keeps a tight fit to the front of the truck, and it adds front-end protection for off-road use.
Each Stealth Fighter bumper comes with the patented universal light mount system in the center. It takes up to 10 cube lights or a 40-inch radius light bar, and any brand and size of light can be mixed on it. Additional lighting behind the side panels can hold a single cube light per side.
The bumper is winch mount compatible and is full width. It is built with clevis mounts for D-rings, so it gives the Ranger a recovery point at the front. It does not include a hoop or a stinger, and the light mounts are included with the bumper.
The Ranger’s front end is protected by the steel plate, and the center light mount is set up to carry the light bar or cube lights you choose for trail use.
Key features
- Radius plate steel design that keeps a tight fit to the Ranger’s front end
- Winch mount compatible, full width
- Universal center light mount for up to 10 cube lights or a 40-inch radius light bar
- A single cube light mount behind each side panel
- Reinforced clevis mounts for D-rings
- Black finish with light mounts included
Recovery and winching basics
A front bumper with a winch mount sets the recovery point at the front of the truck, where the steel plate and clevis mounts take the load. Recovery straps and D-rings should be rated for the job, and the winch should be sized for the truck and the load it will pull. Keep the line centered on the bumper and avoid pulling at an angle that twists the mounts.
Lights on a bumper change how the front end sits and how the wiring moves. Pick a light bar or cube set that matches the mount size, and use a wiring harness with a fuse and relay. Check the light mounts and bolts after rough trail runs, and re-tighten any hardware that has worked loose.
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Part number | ADSF221203030103 |
| Position | Front |
| Width | Full |
| Material | Steel |
| Finish | Black |
| Hoop | Not included |
| Stinger | Not included |
| Winch mount | Compatible |
| Light mounts | Included, universal center mount and side mounts |
| D-ring mounts | Included, reinforced clevis mounts for D-rings |
| Installation type | Direct fit |
Vehicle fitment
This bumper fits the 2019 Ford Ranger.
Only the 2019 Ranger is covered by this bumper, and other Ranger model years fall outside its fit. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The black steel front winch bumper with its universal center light mount, the side light mounts and the reinforced clevis mounts.
Not included: A winch, LED light bars, cube lights and D-ring shackles.














