Overview
The Rigid Industries A-Series LED accessory light, part number 480073, is a universal-fit auxiliary lamp for spots where a compact light helps. It suits vehicle cabs, boat cabins, work vehicle beds, the area under a hood and trunks.
The compact aluminum housing is durable, lightweight and waterproof. The A-Series comes in several LED colors and in high and low power versions, and it can be installed on most surfaces with the included mounts.
Key features
- Universal-fit design, not built for one vehicle
- Durable compact aluminum housing
- Lightweight and waterproof body
- Several LED colors, high and low power versions
- Side or bottom wire exit through the radius tube-mount adapter
Mounting and wiring choices
A compact light like this works best when the mount matches the surface. A flat face suits the rubber flat-mount or the 3M VHB pad, while a curved or angled panel usually needs a radius tube-mount adapter. The adapter also sets the wire exit, so decide on side or bottom routing before you drill or bond anything.
Keep the wire run short and clear of hot exhaust parts, sharp edges and moving components like hinges or tailgates. Adhesive pads hold best on clean, dry metal or plastic, while bolted mounts need a backing check behind the panel. Test the light on a bench before permanent fitting so you can confirm the beam and the wire length.
- Clean and dry the surface before bonding
- Check the backside of the panel before drilling
- Use a fuse on the power feed
- Recheck the mount after rough trips
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 480073 |
| UPC | 849774018404 |
| Housing | Durable compact aluminum |
| Construction | Lightweight, waterproof |
| LED options | Variety of LED colors; high and low power versions |
| Mounting hardware | Rubber flat-mount, 3M VHB two-way pad, radius tube-mount adapters |
| Wire exit | Side or bottom, via tube-mount adapters |
Vehicle fitment
It is a universal fit lamp, so no year, make or model applies. Where it works depends on the mounting surface and wire route you choose.
Because placement is up to you, check that the surface suits the flat pad or tube adapter before mounting. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pick one mount per location: the rubber flat-mount, the 3M VHB two-way pad, or a radius tube-mount adapter. The tube adapter sets the side or bottom wire exit. Run power through a fuse, and check local rules before fitting an auxiliary light to a road vehicle.
What’s included
Supplied hardware: rubber flat-mount, 3M VHB two-way pad for flat mounting, and radius tube-mount adapters.
Not included: The power harness, switch and fuse are not included, so supply them before installing.









